Friday, 28 August 2015

Turning Cardboard in to Plywood

Two plywood sheets have been cut from the cardboard template to match the curve of the hull, sheathed in biaxial glass cloth and checked for fit...


Some lengths of foam have been cut to form a foam radius fillet that will sit between the inside of the hull and the plywood, just the same way the bulkhead was laminated to the hull, reducing any hard spots.

I have checked both sides by way of a dry run to make sure it all fits neat and square, the piece of cardboard between the stowage compartments is purely for support whilst I measured up.


No comments: